 |
 |
|
37-38 The Wings were carved out of 5mm "Perspex" ("Plexiglass") The final castings had to have three 1/8th inch bore brass tubes inlaid in them to carry the wiring for the the neon lights I planned to use to simulate the Warp engines!
|
|
 |
 |
|
39-40 These photos show close-ups of the fine detailing and considerable amount of cladding along the top of the secondary hull. Blending the wings into the main body, bearing in mind they had to carry a considerable amount of wires, was also very difficult, and again showed that a bend seen in the lower wings in some photos appears not to be there in others!
|
|